The Cape Dory Board

if you dont mind pls reply on my pm.. I have always been very happy with their service and advice

I have been calling mack boring in NJ for 10 yrs and they have been very very helpful and have spent as much as 45 mins explaining how to change the oil in my cd27..the point is give them a call you will not be disappointed

the rudder is less effective in reverse because there is less prop wash when the prop is operating..You need water flowing past the rudder to allow it to act as a control surface. in other words when the prop is in foward it sends a large volume of water past the rudder (you knew that didnt you?) Ne...

You have some type of connection issue...I cant visualize the connection.but here are some thoughts backed up by 25 yrs of connector experience. you may have a connection that loosens up over time..dab the joint with a connector paste or tuner spray. then tighten it up and secure the thread with med...

can you describe how the screw is attached to the block ?are the wires going into the block or is there a terminal at the end??

Could have had mine for 13K
If anyone needs a crew for del just call 864-561-8898

waht parts? pls post on board

I would be happy to pay for the shipping and nominal cost for the dodger!~!!!!!!!!!!

how about a 27?

Ok don't get angry
but I have followed your pursuit of a good vessel for some time and she is priced right
and in great shape.
So here is a chance to get your boat !!!!!!I will even help you deliver her!!!

it was helpfull not helful

I have been on the board for about 10 yrs. I would call Spartan ,they are very helfull and knowledgble....it will save you a lot of time..by the way dont dont dont]expect the waste hose to just jump back on the valve fitting ..some yards use a tool to heat the hose up and expand it so that it fits.....

you can safely crimp if you have three things the tool matched to the terminal proper use of the tool by operator wire that is stripped properly trillions of crimped teminals are on ships and aircraft. In my previous job as a indl salesman I had the honor of providing a crimp terminal on one of the ...

I used to sail on the LI sound..frostbitting near Mamaroneck.on a dyher dhow 9'. season started nov and ended april,we had 9 races every Sunday each one lasting about 15 mins.. I capsized once after bailing out my boat which swamped 2x due to a oil tanker swell..I gave up bailing the third time..I w...

dont buy cheap when doing brake jobs ,brain surgery or valves..look at it this way the 200 dollar valve protects ( you fill in the blank)
ALSO a 1 1/2 " nipple on a valve will not accept 1 1/2 hose..some times they need to be heated and softened up to fit on the nipple..