Speedseal

[moctrams]

I have two (2) Speedseal covers for a six (6) screw Jabsco pump that I bought for my old Volvo MD7A. One is new in package and the other is used and still OK. Check out their web site for price.
I will sell the one for $45.00 plus shipping and the used one for $35.00 plus shipping. I will also include extra seals.
http://speedseal.com/speedseal.html

[Stan W.]

The pump on an MD7A is made by Johnson, not Jabsco. I'm guessing you've got the right covers for the Johnson and just confused the J names.

[moctrams]

Not confused at all. The pumps on my old MD7A were Jabsco
2760-0001 , six (6) screws. I'm holding one in my hand now that I'm selling on eBay.

[moctrams]

Volvo Bulb Holder Pt # 74170
One (1) used Volvo Md7A instrument panel bulb holders.

Volvo Temperature sensor Pt # 507419021
One (1) Used Volvo MD7A Temperature Sensor.

Volvo MD7A Fuse unit
One (1) new Volvo MD7A unopened Volvo Fuse Unit with four (4)15A fuses.

Volvo md7a alternator pulley
This pulley was used on my old Volvo MD7A to run a Balmar 621 Alternator.
The retail price was $90.00 plus shipping. You can save a lot.

[Stan W.]

Not confused at all. The pumps on my old MD7A were Jabsco
2760-0001 , six (6) screws. I'm holding one in my hand now that I'm selling on eBay.

Is this a shaft-driven pump on the back (transmission) end of the motor or a belt-driven pump on the front (flywheel) end of a motor with fresh-water cooling?

Thanks.

[moctrams]

Belt driven on back of engne (This engine had a V-Drive)

[moctrams]

Pump was on the flywheel side.

[Stan W.]

Those pumps were not Volvo original equipment but, instead, were part of the after-market fresh water cooling conversion. Both Jabsco and Johnson make pumps which would be interchangeable in that application. The pumps I was thinking of are the shaft driven pumps that run off the back of the fuel injection. Those are Volvo original equipment and as far as I know those are all Johnsons.