We are close to setting a sail on our newly renovated CD 14. I have only to install running rigging. There was nothing left from the original setup to guide us, and I would like to continue to rig the boat with the original plan.
Question, where does the halyard tie off, and would it be a good idea to run it back to the stern area with a turning pulley?
Question, how is the main sheet rigged. and where cleated?
Thanks again. This board has been a great help. Ron B
Running rigging on a Cape Dory 14
Moderator: Jim Walsh
-
- Posts: 87
- Joined: Nov 3rd, '05, 16:44
- Location: Cape Dory 22 Cd14s
details here...
Hi, Ron
http://www.capedory.org/specs/brochures/CD10_14.pdf
Shows how it is rigged. The halyard runs down to the bow and then aft to a cleat. The sheet, as is typical on small dinghies, is not cleated but just hand-held so it can be dumped quickly in the event of a gust.
http://www.capedory.org/specs/brochures/CD10_14.pdf
Shows how it is rigged. The halyard runs down to the bow and then aft to a cleat. The sheet, as is typical on small dinghies, is not cleated but just hand-held so it can be dumped quickly in the event of a gust.
-
- Posts: 87
- Joined: Nov 3rd, '05, 16:44
- Location: Cape Dory 22 Cd14s
CD 14 rigging
Wow I couldn't ask for more than that. Sure is simple. A few more piecies to install, and it's sail time.
Thanks for the help. Ron B
Thanks for the help. Ron B
CD14 Running Rigging
On the CD14 I'm restoring now, the main sheet begins at a stern traveler and then to a block along the end of the boom to another block about mid-boom. Then the sheet then heads down to a swiveling block with jaws on the board just aft of the mid-seat board. Then the sheet is controlled by the helmsman.
As was stated above, the halyard runs to a fitting just ahead of the mast and then to the starboard side to be tied off on a cleat about 3 feet aft on the inside rail.
I can't send pics since all the fittings are still off the boat.[/img]
As was stated above, the halyard runs to a fitting just ahead of the mast and then to the starboard side to be tied off on a cleat about 3 feet aft on the inside rail.
I can't send pics since all the fittings are still off the boat.[/img]