The Cape Dory Board

I can't figure out how to post a photo but I can post the link that has a picture. http://www.bluemoment.com/manuals/VolvoMD11C_D_17C_D.pdf On the link, go to page 29, item #82. The tool and nut are on the left side. The absolute cheapest I have been able to find this tool online is for $112.00 plus...

Thank you, it was a great tip. I got all excited and when I spoke with Noreen this morning she said that she would have to order it from Volvo and it is on back order. I got the same response from other dealers that I spoke with. No one seems to know how long this back order will take, as there is n...

Thank you, it was a great tip. I got all excited and when I spoke with Noreen this morning she said that she would have to order it from Volvo and it is on back order. I got the same response from other dealers that I spoke with. No one seems to know how long this back order will take, as there is n...

The problem is that it has to be tightened from the top, as there is no swinging room in the engine compartment. On the MD11D, they changed the design and used an actual nut that can be tightened with a wratchet. It's really a poor design, unless of course one has the correct special tool.

I am trying to find a torque wrench for a Volvo Penta MD11C. The part number is 884714. It is to tighten the oil strainer nut. It has four little nubs that insert into the "nut" and must be tightened to 70 nm. I have checked everywhere and tons of dealers. The engine was built between 1975...

All 7 of my stanchion bases need to be replaced as they are corroded right at the weld. 2 have broken off completely. Is it possible to keep the flat part of the base and have a new pipe receiver welded on or do I need to replace the whole thing. They are stainless. I have not been able to find, any...

All 7 of my stanchion bases need to be replaced as they are corroded right at the weld. 2 have broken off completely. Is it possible to keep the flat part of the base and have a new pipe receiver welded on or do I need to replace the whole thing. They are stainless. I have not been able to find, any...

All 7 of my stanchion bases need to be replaced as they are corroded right at the weld. 2 have broken off completely. Is it possible to keep the flat part of the base and have a new pipe receiver welded on or do I need to replace the whole thing. They are stainless. I have not been able to find, any...