FOR SALE: MAX PROP

Troy Scott · Post by **Troy Scott** » Jan 24th, '11, 23:42

Folks,

I have a three-blade Max Prop that is set up for a 1" shaft. About six years ago, it was installed briefly on a Pearson with a 3/4" shaft. It was never actually used. When I thought I might use this prop on my CD36, I sent it back to the factory service folks so they could go through it and make sure everything was in order and modify it properly for a 1" shaft. Now I have decided I don't want to use it. It is still packed from the factory service and modification, so it's essentially "like new". I want to sell this prop. I believe a new one like it is about $2,400. I would sell this prop for half price, or about $1,200. If you would like to have it, or if you know someone who might want it, please let me know.

Joe Mac Phee · Post by **Joe Mac Phee** » Jan 26th, '11, 10:50

Troy,

What is the blade diameter of your MaxProp?

Joe Mac Phee

Troy Scott · Post by **Troy Scott** » Jan 26th, '11, 23:39

Joe,
The diameter is 15". I have the original manual. I have the contact information for the factory guy who did the rework for PYI. If you are interested I can share this information....

Joe Mac Phee · Post by **Joe Mac Phee** » Jan 27th, '11, 13:13

Troy,

Thank you for your prompt reply. The prop diameter is too large for my aperture.

Good luck in your sale.

Joe Mac Phee

The Cape Dory Board

FOR SALE: MAX PROP

FOR SALE: MAX PROP

feathering prop

max prop info

max prop