Traveler Car Pull-Stop

[ckreitlein]

I need a pull-stop pin for my main sheet traveler track. It rides in the track and limits the movement of the traveler car. There are two on each track. Another CD owner sold me a couple he had left over after replacing his with new adjustable stops. Unfortunately, they were not the correct size and worthless to me. Mine are original to the boat, made in Australia - FICO. The two inside slots of the stop (that fit over the traveler track) are critical. Both slots are 7/8" wide. The top slot is 1/4" high, the bottom slot is 3/8" high. I would appreciate hearing from anyone who might have one or two left over after replacing their original set up with an adjustable rig. Thanls

[Bruce Ebling]

I have a pair from a CD25D if they aren't too small.
Bruce Ebling

[ckreitlein]

Thanks for the offer. Please measure them very closely and let me know if they are what I need. As I said, the inside that sits on the traveler track is 7/8" wide and 1/4" high. The second slot that runs along the traveler under the top flat track is of course the same width but 3/8" high.

Please let me know if yours match these dimensions. You can send me a personal email here and let me know how much you would like for one or both. I live in Pensacola, Fl. Thanks again.

[ckreitlein]