Recently, My bow pulpit bent and it need to be replaced. I can't get in touch with Ocean Engineering. Does anyone have any suggestions to the whereabouts of another company that manufactures bow pulpits for the CD25. Thanks
MDavis6265@aol.com
Bow Pulpit for CD 25
Moderator: Jim Walsh
-
Don Sargeant
Re: Bow Pulpit for CD 25
I bought a stern pulpit from Defender for my old boat. The off the shelf one they sell is not as nice as the CD OEM but was strong enough to sit on, and very cheap.
Mike Davis wrote: Recently, My bow pulpit bent and it need to be replaced. I can't get in touch with Ocean Engineering. Does anyone have any suggestions to the whereabouts of another company that manufactures bow pulpits for the CD25. Thanks
-
Duncan Maio
-
Frank Vernet
Re: Bow Pulpit for CD 25
Mike,
You've probably already looked into this but most rails can be straightened (if not bent too badly). The bow pulpit rails (1" dia)on Sirius, CD33, were bent during shipping from Puerto Rico and a local Annapolis rigging shop proposed removing, straightening and reattaching the bow rail assembly. Would have taken approx. 5 hrs labor - far less expensive than an outright replacement.
Hope this helps.
Frank Vernet
CO Sirius
CD33
frank.vernet@bmdo.osd.mil
You've probably already looked into this but most rails can be straightened (if not bent too badly). The bow pulpit rails (1" dia)on Sirius, CD33, were bent during shipping from Puerto Rico and a local Annapolis rigging shop proposed removing, straightening and reattaching the bow rail assembly. Would have taken approx. 5 hrs labor - far less expensive than an outright replacement.
Hope this helps.
Frank Vernet
CO Sirius
CD33
frank.vernet@bmdo.osd.mil