Yanmar 1gm oil leak

Discussions about Cape Dory, Intrepid and Robinhood sailboats and how we use them. Got questions? Have answers? Provide them here.

Moderator: Jim Walsh

Post Reply
abcnuzeman
Posts: 55
Joined: Mar 17th, '10, 06:49
Location: '82 Cape Dory 25D
Brooklyn, NY

Yanmar 1gm oil leak

Post by abcnuzeman »

I've got an oil leak on my '82 CD25D...somewhere on my Yanmar 1gm. I replaced the two oil lines on the front of the engine last season after the one running under the raw water pump rusted and sprung a pin hole leak. This current leak doesn't seem to be coming from there but I haven't been able to chase down the source. The oil ends up in the bilge, I'm not burning it judging by the exhaust smoke. Has anyone had any similar experience or suggestions as to how to proceed. I'm concerned I'll have to haul the boat, pull the engine and have it overhauled. Obviously, expenses I'd like to avoid if possible. And just as an aside, anyone know a diesel mechanic in or near Brooklyn that might take on such a project as I know just enough to make things worse instead of fixing them. Thanks in advance.
User avatar
Sea Hunt Video
Posts: 2561
Joined: May 4th, '11, 19:03
Location: Former caretaker S/V Bali Ha'i 1982 CD 25D; Hull 69 and S/V Tadpole Typhoon Week

Re: Yanmar 1gm oil leak

Post by Sea Hunt Video »

"I know just enough to make things worse instead of fixing them."

I have that problem as well. :(

Since you cannot presently locate the source of the leak would it be possible to line the engine sump and surrounding areas with diapers to see if you can more accurately spot where the oil leak is coming from :?: Unless oil is "spraying" around the engine compartment I would think oil drops would deposit below the leak.

Any chance it is coming from or near the oil filter :?: I would initially suspect the replaced oil line connections since those are the only items replaced other than the oil filter.
Fair winds,

Roberto

a/k/a Sea Hunt "The Tadpole Sailor"
CDSOA #1097
________________________________
"I wish to have no Connection with any Ship that does not Sail fast for I intend to go in harm's way." Captain John Paul Jones, 16 November 1778, as quoted in Naval History and Heritage Command, http://www.history.navy.mil
User avatar
Bob Lascelles
Posts: 198
Joined: Jan 19th, '13, 18:08
Location: S/V Vindolanda CD25D #111 1983

Re: Yanmar 1gm oil leak

Post by Bob Lascelles »

I just finished replacing the front two oil lines on my 1GM. While I was doing that I noticed there is a 3rd cleverly concealed external oil line on the back of the engine. Maybe goes to the head. It has the same kind of banjo fittings as the front oil lines. Maybe check that line with a bit of paper towel and see if you getting leaking from the line or the end fittings. Good luck

Bob
Bob Lascelles
CD25D Vindolanda #111
York, ME
User avatar
David Morton
Posts: 437
Joined: Jun 18th, '13, 06:25
Location: s/v Danusia CD31, Harpswell, ME

Re: Yanmar 1gm oil leak

Post by David Morton »

Not to give you nightmares, but... I had some "minor" leaking on my 1GM powered CD25d that i traced to where the transmission housing attached to the engine, only to discover a blown rear oil seal! Would be careful about depending on your engine until you nail down the source of the leak. Good Luck!

David
"If a Man speaks at Sea, where no Woman can hear,
Is he still wrong?
" anonymous, Phoenician, circa 500 b.c.
Post Reply