The Cape Dory Board

CD 28 for sale Placida Florida contact Paul Marko ph 209 988 0944 or email dmarko@aol.com

My Cape Dory (IXCATL) 28 is for sale, bought her new in 1977. She has sailed on SF bay, California and East coast.

Ixcatl can be seen at Charlotte Harbor Boat Yard Placida Florida

contact me by phone Paul Marko 209 988 0944 and I will make arrangements for her showing.

Thanks for the lead on Farymann parts, I have contacted South Carolina but the response was negative.

I will try the Orlando dealer.

Thanks again
Paul marko

I would like to purchase an exhaust and intake valve for my old but dependable Farymann motor. I have owned the cd 28 since 1977 and would like to keep the original motor. I would like valves , new,used or reconditioned. Paul Marko. tel. 209 988 0944 ixcatl located Charlotte harbor Boat storage Plac...

I have a 1977 cd 28 with a one inch shaft. It still has the old Farymann a 30 and the mounts are LARGE rubber pads. The proper motor /shaft alignment has always been problematic.

Ditto previous comments on head room. I have owned my CD28 since 1977, I am 6' 4" and have not found head room to be an issue,


Paul Marko

Ixcatl CD 28

Florida

Rust on the bow plate c/d 28 use a small ball pin hammer, put on some protective glasses, dust mask . Then beat the hell out horizontal, vertical plates, and the associated rebar inside the anchor locker, shop vac out mess,see how much thickness is left on plates. At this point if your satisfied wit...

Many thanks for the photos of the fold down table in a CD 28. I would like a closer look at the hardware used, but I can make up something that will work. Again, thanks for the photos!

Oh ok. I HAVE seen a picture of a 28 with that. Of the OP wants to put one in, the bulkhead one is super cool. It's big so at night I can put my laptop on it and watch a movie with room for two people to eat and not feel crowded. It folds up rediculously small and out of the way too. It feels very ...

Thanks for all the suggestions about the fold down table, pros and cons I have not make up my mind yet. If someone could post a photo of the hardware required fpr the fold down model that would be helpful..

Thanks again for the time taken for your response

Paul Marko

Thanks for all the suggestions about the fold down table, pros and cons I have not make up my mind yet. If someone could post a photo of the hardware required fpr the fold down model that would be helpful..

Thanks again for the time taken for your response

Paul Marko

the reason for the quiery about a fold down table, results from my last sailing guest who felt the constant presence of the tube supported table limited good conversation and ease of movement in the main cabin. the storage area for the tube table is full so I normally leave it in place.

I am trying to locate some plans or pictures of a fold down table for the main cabin of my CD 28 to replace the original tube supported table.

I agree with all the previous posts


Paul Marko

The way I fixed this problem was to install grease zirk on the shaft just below the tiller head. once a season I put three pumps of water proof grease and voila no leak form the rudder shaft housing. The leak occurs due to the gravitation from the prop.

Paul Marko

ixcatl C/D 28